The board power design unit within R&D center in Beijing is responsible for Ericsson Radio, Digital and broadband products board power design according to the system requirement. Main challenge is to make the design more power efficiency, smaller and cheaper meanwhile keep the good quality.
Design board power solutions according to system requirement
Cooperate with PCB layout engineer to allocate your design on the board
Verify your design solution to ensure quality and performance
Trouble shooting and solution proposal for problems found from customer sites
New technology research and implementation in pre-development project
Work closely with other R&D departments in Sweden
Qualifications & Requirements:
Master degree or above of first level University major in electrical engineering or related area is preferred
Fluent in English speaking and writing.
High Energy levels, positive as a person with a can do mentality with high drive ability to get things done
Energize others by spreading a positive energy
Edge you can take tough yes/no decision and implement them
Passion for new technology and also care colleagues
High Execution/Delivery ability, deliver on time and commitments and constantly work on efficiency improvements
Integrity and Presentation, state things as how it is Clearly and with structure
Perseverance, dig into the detail of every problem and never give up
Good cooperation with others
Familiar with basic DC/DC topologies, e.g. BUCK, forward and full bridge etc.
Familiar with magnetic component design.
Digital controller firmware development or other programming experience is preferred.
Familiar with power loss and tolerance analysis